About haas st 15 lathe
About haas st 15 lathe
Blog Article
Stage-by-move Recommendations and graphics support manual the operator in the setup system, one example is:
Risk: At this point, there needs to be no electrical connection to your device. Electrical panel have to be shut and secured. When key switch is on, There's HIGH VOLTAGE all over the electrical panel (such as the circuit boards and logic circuits) plus some factors operate at higher temperatures. Therefore, training Extraordinary caution when Operating during the panel.
Enable it soak for a couple of minutes ahead of taking away it using a store towel. It can be reccomended to apply mineral spirit or WD-40 to all uncovered metal surfaces for rust proofing.
It's entirely up into the operator/operator to ascertain if and what sort of mist extractor is finest suited to the appliance.
secondary spindle. In the event the turret crashes, the lathe can lose its alignment. This process informs you the best way to correct the lathe
Move the turret back towards the spindle as much as possible and raise or reduce screw one to Heart the bubble. Proceed moving the turret with the dwelling situation to the spindle and altering screw one and a pair of until the twist is taken out.
It can be up to the owner/operator of your equipment to determine if personalized protective devices which include protection goggles or perhaps a respirators is required as well as if a mist extractions technique is required.
Tend not to function the equipment Unless of course the doorways are shut as well as door interlocks are functioning the right way.
Now think about the greater stage that's parallel into the turret experience and lift or lower screw one to Heart the bubble.
Shift the turret back to the spindle as much as you possibly can and lift or reduced screw one to center the bubble. Continue on shifting the turret within the home placement for the spindle and changing screw 1 and three right until the twist is taken off.
Mount the indicator on the turret and also the spindle bar for the spindle and align the Resource by checking the runout at The bottom and close of your Device (NTE 0.0002").
Single-Head Rotary Solitary-Head Rotary Tables and Indexers are often mounted to the appropriate facet in the desk, Along with the rotary going through the centre with the device. This is the simple setup we made use of to determine the match of your rotary product or service.
Be aware: True sounds ranges though reducing substance are tremendously afflicted from the person’s decision of fabric, chopping resources, speeds and feeds, workholding and also other factors. These factors are application precise and so are managed from the person, not Haas Automation Inc
It is supplied having a HAAS control details device and it has three axis. The device incorporates a spindle speed of 8100 rpm, is in good condition and perfectly preserved. Software Varieties